How to Guide: Replacement of a Defective Washing Machine Belt

Repairing our home appliances is no easy task! It is more often time-consuming, difficult, confusing and eventually frustrating. Not to mention that it can be dangerous especially if you are doing it on your own without any help from professional technicians. Then again, hiring a skilled repair man to fix your appliances like the washer can be a pain to your pocket too. It can be quiet expensive! This article aims to provide a simple guide on the replacement of the drive belt on a washing machine, one of the easiest and most common household appliance repairs.

The washing machine drive belt does a lot of work, it moves the agitator, it spins the barrel, and it’s the thing that makes things move inside your washer. Without this rubber belt, you could never get your clothes clean. That being said, this is the most common and easy to break part on any washing machine. When the belt on my Maytag Dependable Care Plus washer recently broke, a little research saved me a lot of money.

It is important to note also that belts are made of rubber lg washer repair los angeles. Thus, they can easily dry out and crack. Excessively large loads can strain them. If fabrics get tangled in the agitator it can cause the belt to smoke and shred. So to keep the belts protected and your washer running longer, make it a point to sort your clothes before doing the laundry. Take large curtains, rugs, blankets, and comforters to a Laundromat and wash them in large, industrial size washing machines.

Begin your repair by unplugging the electrical cord. This I guess should be given utmost attention and should never be ignored, because your safety relies on it. After unplugging the electrical cord, you can then start unhooking the water connections. Then check if your washer has access panel and remove them. On the Maytag Dependable Care Plus washer, the drive belts are located at the bottom of the machine.

After locating the drive belts, you may turn or position your washer on a side comfortable for you to work around. It would also be advisable to place your washer over dry cloth to avoid water from spilling all over the place. Proceed with removing the clamps that connect the rubber coupling, the belt and washing machine motor. Slide the old drive belt off and replace with the new one, then reconnect the rubber coupling and the clamps over the new washing machine belt. Then finally, re-position your washer in place, connect the power cord and turn it on to check if it now runs properly.

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*